Metabo HPT NT 1865DMA Manual De Instrucciones página 23

(9) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
LOADING NAILS
● When loading nails into Nailer,
1) remove battery from the nailer;
2) do not pull trigger;
3) do not depress push lever; and
4) keep nailer pointed downward.
<NT1865DMA, NT1865DM>
2–Action Nail Feeding!
(1) Insert nail strip into the back of the magazine.
Magazine
(2) Slide the nail strip forward in the magazine.
WARNING
(3) Push the nail feeder (A) to engage the nail feeder (B)
to the nail strip.
Nail feeder (B)
NOTE
● Quietly push the nail feeder (A) and nail feeder (B)
against the nail.
If the nail feeder (A) and nail feeder (B) are released
from backward the magazine and bumped against
the nail, the connecting adhesive of the nail can be
damaged.
● Use nail strip of more than 10 nails.
● Use an unbroken nail strip with nails of all the same
length.
The Nailer is now ready to operate.
Removing the nails:
1 Pull the nail feeder (B) backward.
2 Return the nail feeder (B) forward quietly while
pushing the nail feeder (A).
3 Pull out nails from the back of the magazine.
1
2
Nail feeder (B)
English
Nail feeder (A)
Nail feeder (A)
3
Nails
23