Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Produce Preserver (on some models)
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium
permanganate. If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.
The Produce Preserver pouches should be installed in their housing,
which is located along an interior side wall of the crisper or convertible
drawer.
NOTE: For best performance, always use two pouches.
1. Remove the Produce Preserver pouches from their packaging.
CAUTION
IRRITANT
Read cautions on back.
Whirlpool Corporation, Benton Harbor MI 49022
2. Lift up on the housing in order to remove it from its mounting tab
along the wall.
3. Open the housing by pulling up and out on the back of the top of
the housing.
4. Place both pouches inside the housing, then snap the housing
back together.
5. Place the housing back on the mounting tab along the wall.
12
12
All manuals and user guides at all-guides.com
ATTENTION
IRRITANT
Lire les mises en garde au dos.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which should be
activated and installed at the same time the pouch is installed.
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until the
bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible through
the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear bubble
has not been popped.
Replacing the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months, when the
status indicator has completely changed from white to red.
To order replacements, see "Accessories" in the User Instructions or
User Guide.
1. Remove the old pouches from the Produce Preserver housing.
2. Remove the old status indicator.
3. Install the new pouches and status indicator using the instructions
in the previous sections.
REFRIGERATOR USE
Using the Controls
The refrigerator and freezer controls are located on the dispenser
panel.
IMPORTANT: The display screen on the dispenser control panel will
turn off automatically and enter "sleep" mode when the control
buttons and dispenser pads have not been used for 2 minutes or
more. While in "sleep" mode, the first press of a control button will only
reactivate the display screen, without changing any settings.
Touch any control button on the dispenser panel to activate the
display screen. The home screen will appear as shown.
Calibrate Measured Fill
Publicidad
