MANUAL - FREESOUND400
•
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
CHARGING THE BATTERY
1. Connect the mains power plug to an AC outlet and the built-in battery will start charging, no matter if the
speaker is on or off. On the display, the battery charging symbol will run from 1 to 3 cells.
2. Once the battery is fully charged, it will display steadily 3 cells.
PLEASE NOTE: If the speaker has been switched into standby mode via the remote control, the built-in battery
will NOT charge.
1. PRIOR TO USING THE UNIT FOR THE FIRST TIME, PLEASE CHARGE FULLY THE BATTERY WITHOUT ANY INTER-
RUPTION.
2. CHARGE THE BATTERY REGULARLY AFTER EACH USE. DON'T WAIT UNTIL IT IS DISCHARGED!
3. DON'T ALLOW THE BATTERY TO DISCHARGE COMPLETELY! ONCE THE BATTERY IS FULLY DISCHARGED, THE
CURRENT DRAIN FOR RECHARGING WILL BE SO HIGH THAT IT WILL DAMAGE THE CHARGER AND/OR THE POWER
SUPPLY OF THE UNIT.
4. IF YOU DON'T USE THE UNIT FOR A LONGER PERIOD OF TIME, PLEASE CHARGE THE BATTERY COMPLETELY AT
100% AND CHECK/CHARGE IT ONCE PER MONTH OTHERWISE THE BATTERY WILL BE OUT OF USE.
THE LIFE TIME OF THE BATTERY DEPENDS ON THE OBSERVANCE OF THESE RECOMMENDATIONS.
WE CANNOT BE HELD RESPONSIBLE FOR DAMAGED BATTERIES FURTHER TO THE NON-OBSERVANCE
DESCRIPTION OF THE TOP PANEL CONTROLS & CONNECTORS
1. Microphone input
2. Microphone input
3. Line in
4. USB input
5. TF card input
6. Power ON/OFF
7. LED Light Switch
8. MIC Volume
9. Main Volume
10. Echo-
11. Echo+
12. Record function
13. Change Light mode
14. Repeat function
15. Previous song
16. Next song
17. Pause/Play
18. Mode: Line in, USB mode, TF Card, Wire-
less BT
19. Wireless BT function
20. Mega Bass
21. Menu: Bass adjustment and treble adjust-
ment
IMPORTANT NOTE ON LEAD-ACID BATTERIES
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
OF THESE BASIC RULES.
3