Publicidad
Idiomas disponibles
Idiomas disponibles
If power is disconnected from the instrument before saving the settings (pressing the
the changes made to the parameters and temporarily saved will be lost.
4.
SETTING PARAMETERS (EVC80 VERSION)
It is only possible to program the configuration settings in STANDBY mode.
There are two configuration levels.
Level 0 (USER)
Level 0 parameters are USER ones that can be
edited directly using the keyboard (e.g. time blast
chilling).
Instructions on how to access these settings:
Press
and
and
buttons for at least 4
seconds and the PA parameter appears
on the display;
Scroll through the settings with the
and
buttons;
Press
the
parameter shown on the display;
one minute without pressing any of the buttons.
Level 1 (INSTALLER)
Instructions on how to access all the settings:
Press and hold both the
buttons for at least 4 seconds and the PA
parameter appears on the display;
Press the
button;
Press the
select the password value
hold
both
the
button
to
edit
the
and
and
buttons to
-19
;
Press the
the value of the setting, and press the
button to save the new value;
Follow the above instructions to edit any
of the other parameters.
To exit programming mode, press and hold both
the
and
buttons for at least 5 seconds
or
Confirm this by pressing the
Press and hold both the
buttons for at least 5 seconds to
open the list of settings;
Select the settings you wish to edit by
pressing the
3
ENGLISH
button for 3 s), all
and
buttons to edit
wait
button;
and
and
buttons;
GB
Publicidad
