Publicidad
Idiomas disponibles
Idiomas disponibles
(see image at last page)
1. Front grille
2. Lock ring of the fan
3. Safety screw of the fan
4. Fan
5. Lock ring of the back grille
6. Back grille
7. Motor shaft
8. Oscillation knob
9. Motor
10. Control panel
11. Main body screw
AR5BR40P
1. Unscrew the screws (16) from the two parts which form the basis of the cross (17).
2. Fit the two parts which form the basis of the cross (17) as is shown in the picture.
3. Unscrew the height adjustment knob (14) from the base rode (15) and insert the small
decorative base (12).
4. Pull out the adjustment rod (13) from the base rod (15) then tighten the height adjustment
knob (14) on the base rod (15).
5. Tighten the base rod (15) with the screws (16) previoulsy unscrewed from the cross base
(17).
AR5BR40PB
1. Insert the base rod (15) into the base's hole (18).
2. Turn over the base (18) so the base rod (15) is pointing the floor then place the weight
(19) on the bottom of the base and tighten it firmly with the screw (20).
3. Turn over the base again with the base rod fixed.
4. Unscrew the height adjustment knob (14) from the base rod (15) and pull the adjustment
rod (13) out from the base rod (15). Tighten the height adjustment knob (14) on the base
rod (15).
AR5BR40P - AR5BR40PB
6. Loosen the screw of the main body (11).
7. Insert the main body on the adjustment rod (13). Tighten the screw (11) for fixing it.
8. Unscrew the locking ring of the rear grille (5) from the motor shaft (7) by turning it
counterclockwise.
9. Insert the rear grille (6) on the motor shaft (7) making sure that the handle on the back is
facing upwards and the locking pins (A-B) are in the vertical holes of the rear grille. Screw
the locking ring (5) by turning it clockwise.
10. Place the blade (4) on the motor shaft (7) and secure it by turning counterclockwise the
locking ring (2).
11. Open the clips of the front grille (1) and place it on the back grille (6) making sure that
the logo on the central stud is placed horizontally, parallel with the floor.
13. Find the proper position to lock the clips and insert the safety screw of the grille (3).
Place the fan on a flat, dry and stable surface, and insert the plug of the fan in a socket.
Select the desired speed by pressing the buttons on the control panel (10):
0 =off 1 =minimum speed 2 =medium speed 3 =maximum speed
(EN) ASSEMBLING
12. Small decorative base
13. Adjustment rod
14. Height adjustment knob
15. Base rod
16. Screws for fixing the base rod (4 pieces)
17. Cross base
18. Plastic base
19. Weight of the plastic base
20. Screw for weight fixing
A-B. Locking pin for the rear grille
(EN) INSTRUCTIONS FOR USE
9 / 39
Publicidad
