Sony GDM-400PST Manual De Instrucciones página 13

4
Fine tuning the color temperature
Press the ¨./> buttons to select an item and adjust by
pressing the >?// buttons.
Select R (red), G (green), or B (blue) BIAS to adjust the
black level of each color's signal.
Select R (red), G (green), or B (blue) GAIN to adjust the
white level of each color's signal.
The "5000K," "6500K" or "9300K" disappears and the
new color settings are memorized for each of the three
color modes.
The color temperature modes change as follows:
5000Kn 1, 6500Kn 2, 9300Kn 3
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on. The
selected item is reset to the factory settings.
Using the SCREEN On-screen
Display
COLOR
You can adjust convergence settings to eliminate red or blue
1 6500K 9300K
shadows that may appear around objects on the screen.
R B I AS 76
G B I AS 50
Adjust the CANCEL MOIRE function to eliminate wavy or
B B I AS 50
R GAIN 50
elliptical patterns that may appear on the screen.
G GAIN 50
B GAIN 50
Adjust the LANDING function to correct color imbalances
at the four corners of the screen due to influence from the
earth's magnetism.
Once CANCEL MOIRE is adjusted, it will be stored in
memory for the current input signal. All other adjustments
will be stored in memory for all input signals received.
1
2
3
Select
H CONVERGENCE
V CONVERGENCE
V CONVER TOP
V CONVER BOTTOM
Getting Started
Customizing Your Monitor
Press the MENU button.
The MENU OSD appears.
MENU
Press the ¨./> and >?// buttons to select
" SCREEN," and press the MENU button again.
The SCREEN OSD appears.
Press the ¨./> buttons to select the item you want
to adjust.
To
adjust the horizontal convergence
adjust the vertical convergence
TOP adjust the screen's upper vertical
convergence
BOT
adjust the screen's lower vertical
convergence
EN
F
SCREEN
D
TOP
BOT
ES
26
ADJ
I
H CONVERGENCE
(continued)
13