GE AEM12 Manual Del Propietário página 9

WINDOW REQUIREMENTS
1
• These instructions are for a standard
double-hung window. You will need to
modify them for other types of windows.
CAUTION:
bolts do not contact the window sill, or
if you have a window without a sill, you
must order accessory kit RAK87 to
properly install this air conditioner.
Call 800.626.2002 or visit ge.com.
• The air conditioner can be installed
without the accordion panels if needed
to fit in a narrow window. See the
window opening dimensions.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within
reach of the power cord.
25 1/4" to 38 1/8"
(With accordion panels)
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the air
conditioner to tilt toward the outside, and
will keep it from draining properly. To adjust
for this, attach a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the sill to make
it 1/2" higher than the top of the storm
window frame or the vinyl frame.
Attach securely with nails or screws
provided by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
All manuals and user guides at all-guides.com
Installation Instructions
If the sill support
15 1/2" min.
1/2" higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
REMOVE THE AIR CONDITIONER
3
FROM THE CASE
Remove and save the 2 screws from the
A
lower sides of the front grille.
Grasp the lower corners of the grille while
B
pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge
toward you more than 3" or you may
damage the tabs of the grille.
Remove the ground screw from each side
C
of the case. Keep them in a safe location.
Slide the air conditioner from the case by
D
gripping the base pan handle and pulling
forward while bracing the case. Do not
pull or lift on the styrofoam discharge area.
9
FRONT
FRONT
FRONT
Do not
pull or
lift in
this
area—
damage
to the
unit may
result
FRONT