Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Space Requirement
Select a location without direct exposure to sunlight;
y
Select a location with enough space for the refrigerator doors to open easily;
y
Select a location with level (or nearly level) flooring;
y
Allow sufficient space to install the refrigerator on a flat surface;
y
Allow clearance to the right, left, back and top when installing. This will help reduce power
y
consumption and keep your energy bills lower.
Keep at lest 50mm gap at two sides and back.
y
this refrigerating appliance is not intended to be used as a built-in appliance
y
Positioning
,QVWDOO WKLV DSSOLDQFH DW D ORFDWLRQ ZKHUH WKH DPELHQW WHPSHUDWXUH FRUUHVSRQGV WR WKH FOLPDWH FODVV
ٞ LQGLFDWHG RQ WKH UDWLQJ SODWH RI WKH DSSOLDQFH
for refrigerating appliances with climate class:
- extended temperate: this refrigerating appliance is intended to be used at ambient temperatures ranging
from 10 °C to 32 °C;
- temperate: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
32 °C;
- subtropical: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
38 °C;
- tropical: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43
°C;
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best
performance, if the appliance is positioned below an overhanging wall unit, the minimum distance
between the top of the cabi-net and the wall unit must be at least 100 mm. Ideally, however, the
appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by one
or more adjustable feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to
your domestic power supply. The appliance must be earthed. The power supply cable plug is provided
with a contact for this purpose. If the domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if the above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
11
Publicidad
