Publicidad
Idiomas disponibles
Idiomas disponibles
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box and place
it on the floor as shown in Fig.1.
Make sure that all of the pieces are
there: (1) Main structure; (4) side bar
(left); (8) Side bar (right); (15) Allen
screw M8x15; (9) Allen screw M8x60;
(7) Monitor; (40) Safety key; Allen key
5mm; Allen key 6mm; (80) Holder;
(90) Bottle of lubricant.
Follow the instructions step by step to
assemble:
1 First of all take the right side bar (8)
connect terminals (77) (78) Fig.2, then
insert the side bar (8) into the bottom
right-hand support on the structure
and use screws (15) (9).
2 Now take the left side bar (4) and
insert it into the bottom left-hand
support on the structure and use
screws (15) (9) to secure it.
3 At least two people are needed for this
step. When fitting the side bars, one
person should hold the side bar while
the other one fits the screws (15) (9).
This will prevent any possible accidents.
Fig.B
FITTING THE MONITOR.-
4 Connect the control cable terminal
(79) Fig.3, coming out of the monitor, to
the control cable (77), sticking up from
the right-hand side bar (8), and insert
screws (15), making sure not to pinch
the cables, and screw in until hand tight.
Note: Make sure that the cables do
not become caught up when the unit is
folded. Tighten the 4 screws (15) fully.
5 LUBRICATION.-
CAUTION: Before the first use,
apply approximately half the bottle
of lubricant in the central part and
along the entire board, and on both
sides as shown in Fig.6.
(due to different running styles, always
apply more lubrication to the area where
you place your feet during the exercise).
Once the lubricant has been applied you
should neither fold nor use the machine
for a few hours. This will allow the belt to
get well impregnated.
If you have any doubts, an illustrative
video is available on our YouTube
channel
(https://www.youtube.com/c/BHFitnessS
ervice/videos).
If the bottle of lubricant is missing in
the box, please ask for it before using
an inappropriate lubricant.
CAUTION:
supplied by BH or lack of lubrication
leads to loss of warranty.
It is very important to keep the belt
well
lubricated
maintenance and to avoid expensive
damages.
15
Using
lubricant
for
its
not
correct
Publicidad
