Domo DO990TDK Manual De Instrucciones página 38

4. Unscrew the doorstop on the underside of the door. There is a new doorstop in the accessory pocket.
Place the new doorstop on the other side of the door.
5. Remove the screws from the bottom hinge with a Phillips screwdriver.
! Attention: the inclination of the refrigerator must be less than 45° so that the compressor oil does not
enter the cooling circuit. If you do shut down the unit completely, wait 24 hours before turning it back on.
6. There is a doorstop and a Teflon bushing to guide the hinge at the bottom of the door. Move it to the
other side.
z
7. Replace the lower hinge on the other side and secure it with screws.
8. Remove the cover caps from the screw holes of the middle hinge. Unscrew the middle hinge and
place it on the other side. Make sure that the door is aligned both horizontally and vertically so that
the seals are closed on all sides before fully attaching the middle hinge. Replace the cover caps on
the other side.
38
DO990TDK