Publicidad
Idiomas disponibles
Idiomas disponibles
• Before each use, check that the appliance is in good condition and that the power cord is
not damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
The fan heater is equipped with the following adjustment devices:
1)
Insert the plug in the current socket.
2)
To turn on the appliance, turn the selector knob in the position corresponding at the
function requested.
0
Off
fan
Air warm (power 2000W)
air very hot (power 3000W)
3)
Thermostat: regulates the appliance based on the surrounding ambient temperature: it
heats continuously until the set temperature is reached, and then it heats only when the
temperature decreases and for the period of time needed to bring it back up to the set
temperature. Use the respective knob: if turned fully in an anticlockwise direction, the
fan heater stays off (MIN), if fully turned clockwise it is set to the maximum temperature
(MAX); the heater runs at intervals when set to the settings in between.
4)
The indicator light turns on and off when the appliance reaches the set temperatures.
5)
Safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
6)
To turn off the fan heater, please turn the Knob in the "0" position and the thermostat
knob anticlockwise. Then pull out the plug from the socket.
If the appliance is not being used for long periods of time, remove the plug from the plug
point.
13
Publicidad
