Metabo HPT EC 1315S Manual De Instrucciones página 13

BREAKING IN THE PUMP
○ Check and tighten all bolts, fi ttings, etc.
○ Pull the pressure regulator knob out and turn fully
clockwise to open the air fl ow. (Fig. 3)
○ Place the switch in the OFF (O) position and plug in
the power cord.
○ Open the drain valve completely (Fig. 4).
○ Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
○ Place the switch in the OFF (O) position.
○ Close the drain valve (Fig. 4).
TRANSPORT
○ Pull telescopic handle out until it locks into place.
(Fig. 5)
CAUTION: The telescopic handle is only for
pulling the unit. (Fig. 6)
DO NOT lift the unit by this handle.
TRANSPORT
Fig. 5
Fig. 6
Drain valve (closed)
○ To collapse the handle, apply pressure for the fi rst few
inches to unlock, then slide the handle strait in until it
stops. (Fig. 5)
WARNING:
Two person lift.
Do not attempt to lift the
compressor
Lifting the compressor is a
two-man operation requiring
the assistance of another
person. The compressor is
lifted by gripping hand holds
A and B. (Fig. 7)
A
○ When transporting the compressor, do not drop the
unit or allow the unit to fall from a vertical position.
English
Drain valve (open)
Fig. 4
by yourself.
B
Fig. 7
13