EINHELL GE-SP 4390 LL ECO Manual De Instrucciones página 22

7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Cleaning the paddle wheel (Fig. 1/Item 3)
If a lot of deposits collect in the housing, the bot-
tom part of the equipment must be dismantled as
follows:
1. Detach the suction plate from the housing.
2. Clean the paddle wheel with clear water.
Caution! Do not put down or rest the equip-
ment on the paddle wheel!
3. Assemble in reverse order.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_GE-SP_4390_LL_ECO_SPK9.indb 22 Anl_GE-SP_4390_LL_ECO_SPK9.indb 22
GB
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 22 -
24.08.2017 14:46:37 24.08.2017 14:46:37