LG WM4070H A Serie Manual De Propietario página 15

Connecting the drain line
Secure the drain hose in place to prevent moving
and leaking.
NOTE
y The drain hose should be properly secured.
Failure to properly secure the drain hose can
result in flooding and malfunction.
y Total height of the house end should not
exceed 96 inches (244.8 cm) from the bottom
of the washer.
y The drain must be installed in accordance
with any applicable local codes and
regulations.
y Make sure that the water lines are not
stretched, pinched, crushed, or kinked.
Using a standpipe
1 Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose. If the
drain hose is extended more than 4 inches
(10 cm) beyond the end of the elbow bracket,
mold or microorganisms could spread to the
inside of the washer.
Elbow bracket
2
Insert the end of the drain hose into the
standpipe.
3
Use a tie strap to secure the drain hose in
place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
INSTALLATION INSTRUCTIONS
Using a laundry tub
1 Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose. If the
drain hose is extended more than 4 inches
(10 cm) beyond the end of the elbow bracket,
mold, or microorganisms could spread to the
inside of the washer.
Elbow bracket
2
Hang the end of the drain hose over the side
of the laundry tub.
3
Use a tie strap to secure the drain hose in
place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
15