LG WM4070H A Serie Manual De Propietario página 37

Problem
Wrinkling
Power is not turned on
The door does not open
when the cycle pauses or
finishes
The wash cycle time is
longer than usual
It is musty or moldy in the
tub
Banging noise when
washer is filling with water
(Water Hammer)
SPECIFICATIONS
Model WM4070H*A
Description
Electrical requirements
Max. water pressure
Dimensions
Net weight
Max. spin speed
Possible Causes
y Did you remove the load immediately
after it finished?
y Did you overload the tub?
y Did you reverse the hot and cold water
inlets?
y Is the power cord plugged in properly?
y Has a house fuse blown, a circuit breaker
tripped, or a power outage occurred?
y Is the temperature in the tub too high?
y Is the water level in washer high?
y Is the washing machine overloaded? Are
other options added to the wash cycle?
y Has the incorrect detergent been used?
y Did you clean the tub periodically?
y Plumbing in the home moves or flexes
when the water valves in the washer
shut off.
y Household water supply pressure is very
high.
Front-Loading Washer
120 VAC @ 60 Hz.
20 – 120 psi (138 – 827 kPA)
68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
27" (W) X 29 / " (D) X 38
3
4
200.8lb(91.1Kg)
1,300 RPM
y Remove the load immediately after it
finishes.
y Do not overload the tub.
y Hot water rinse can cause garments
to wrinkle. Check the inlet hose
connections.
y Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y Reset the circuit breaker or replace the
fuse. Do not increase the fuse capacity. If
the problem is a circuit overload, have it
corrected by a qualified electrician.
y The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until
the door lock icon disappears from the
display.
y Allow the washer to complete the
programmed cycle, or Press the SPIN
button.
y This is normal. The washing machine
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
y Use only HE (High-Efficiency) detergent
recommended for a front-loading
washing machine.
y See page 30, clean the inside and
outside of the washing machine
periodically.
y Water hammer is not caused by a defect
in the washer. Install water hammer
arrestors (purchased separately at
hardware or home improvement store)
between the fill hose and the washer for
best results.
y Adjust household water supply regulator
to a lower pressure or contact a
plumber to have a regulator installed.
/ " (H), 51" (D with door open)
11
16
37
SPECIFICATIONS
Solutions