Descargar Imprimir esta página

SNOWJOE sunjoe SPX2690-MAX Manual Del Operador página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
• Disconnect the unit from the electrical power supply before carrying out maintenance on the machine or when checking that
its parts are in proper working order.
• To avoid unnecessary hassles, consult the following table before contacting customer service with any mechanical issues.
Problems
• Power failure/machine
Machine
refuses
to start
• Defective socket.
• Tripped circuit breaker.
• Pump sucking air.
Fluctuating
• Valves dirty, worn
pressure
• Pump seals worn out.
• Incorrect mains voltage.
Machine
• Thermal sensor activated.
stops
• Nozzle partially blocked.
• Air in inlet hose.
• Inadequate supply
Machine
pulsating
• Nozzle partially blocked.
• Water filter blocked.
• Hose kinked.
• Pump/spray gun is leaking.
Machine often
starts and
• Trigger mechanism
stops by itself
• Pump/hoses or
Machine
starts, but
• No water supply.
no water
• Water inlet filter blocked.
comes out
• Nozzle blocked.
Possible Cause
not plugged into a
working receptacle.
out, or stuck.
of water.
is broken.
accessories frozen.
Possible Solution
• Check to make sure machine is
plugged into a working outlet.
• Check the power cord and reset the
GFCI. Try a different outlet.
• Switch off any other machines that
are using the same circuit.
• Check the hoses and connections are airtight.
• Clean or replace valves/seals.
• Please call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563) for assistance.
• Check that the mains voltage corresponds
to specification on the model tag.
• Let the washer cool down for 5 minutes, then restart.
• Clean the nozzle.
• Allow machine to run by holding the trigger
until regular working pressure resumes.
• Check that the water supply corresponds
to the specifications required.
• WARNING! Avoid using long, thin hoses
(minimum 1/2 in. diameter).
• Clean the nozzle.
• Clean the water inlet filter.
• Straighten out the hose to remove any kinks/blockages.
• Please call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563) for assistance.
• Wait for pump/hoses or accessories to thaw.
• Connect inlet water.
• Clean the water inlet filter.
• Clean the nozzle.
13
+ Sun Joe
customer service
®
®
+ Sun Joe
customer service
®
®

Publicidad

loading