Volpi KV300 Manual Del Usuario página 40

21. Troubleshooting and repair
Problem
Pruner doesn't start
Intermittent Operation
Hot Blades
Poor Trimming
Performance
Will not charge. Charger
red light flashes.
40
Possible Reason
Battery out of charge
Battery not connected
Safety switch cannot be
initiated
On / off switch failure
Loose internal connections
On / off switch failure
Blade dull
Blade gap
Poor lubrication, resulting in
excessive friction
Lubrication is not in place,
resulting in excessive friction
Dirty blade
Blade dull
Trimming quality is poor
The battery is not fully
charged
The battery is not properly
placed in the charger
The battery charger is not
connected properly to the
power supply
Battery contact point is dirty
Invalid battery
Battery charger is invalid
Corrective Action
Charge Battery
Connect battery
Open by initiating safety on
switch
Send to repair service center
Send to repair service center
Sharpen or replace the blade
Sharpen or replace the blade
Lubricate blade
Lubricate blade
Clean blade
Sharpen or replace the blade
Read the instructions carefully
Charge the battery
Insert the battery correctly
Connect properly
Clean the battery contacts
Replace battery
Replace Battery Charger