Descargar Imprimir esta página

GYS PACK 660 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Translation of the original instructions
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The British
Declaration of Conformity is available on our website (see
home page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website (see cover page).
Disposal:
• This product should be disposed of at an appropriate recy-
cling facility. Do not dispose of in domestic waste.
• The battery fitted in this device is recyclable. Please proceed
according to the applicable recycling regulations.
• The battery must be removed from the device before the lat-
ter is discarded.
• The device must absolutely be disconnected from the power
supply network before removing the battery.
GENERAL DESCRIPTION
The high performance internal battery allows the GYSPACK 660 / 750 to serve 4 functions:
- Test battery
- Instant Start from vehicle equipped with 12V Lead battery (Gel or Liquid electrolyte).
- 12 V DC power supply, to supply light Spot, TV, tools, etc...
- Light
CHARGE THE INTERNAL BATTERY
Before using the device turn the knob to OFF.
Charge the device once bought and after each use with the charger provided.
Do not use another charger than the one provided with the device.
This device is delivered with an automatic charger (for the internal battery), double insulated with a floating system
enabling to keep the internal battery charged to 100% unsupervised.
To charge the internal battery :
• Place the device vertically during charging to avoid acid leaking and damaging the internal battery.
• Connect the charger to a 230V power supply, The green LED lights and the cigarette lighter LED lights red. Connect
the cigarette lighter plug into the side of the device.
• Turn the knob to 12V to start charging. If the knob stays is on OFF or 24V it will not charge.
• The charger LED turns red when the cigarette lighter plug is connected. The charge is in progress.
• The device is charged once this LED turns back to green.
STARTING A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.
The booster must be stored in a vertical position. Any other storage position should only be temporary.
In order to use the GYSPACK 660 / 750 as a starter, follow these steps:
Disconnect the GYSPACK 660 / 750 from the mains. Turn the vehicle ignition key to OFF.
GYSPACK 660 / 750
EN
11

Publicidad

loading

Este manual también es adecuado para:

Pack 750