Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - 36418001
handshower
tub spout
Flow rate - 36416001
handshower
tub spout
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
This trim is for use with rough 10452181 (not
included). The rough must be installed and the finished
floor surface completed and made watertight.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
• This thermostatic mixing valve is for use with a
showerhead rated at 1.3 GPM (4.9 L/min) or
higher.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.75 GPM (6.6 L/min) max.
5.3 GPM (20 L/min) @ 44 PSI
2.0 GPM (7.6 L/min) max.
5.3 GPM (20 L/min) @ 44 PSI
• 36418001 only: This showerhead is for use
with an automatically compensating valve rated at
1.3 GPM (4.9 L/min) or less.
• 36416001 only: This showerhead is for use
with an automatically compensating valve rated at
1.5 GPM (5.7 L/min) or less.
• Protection against backflow is provided by check
valves.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
