Publicidad
Idiomas disponibles
Idiomas disponibles
Turn the carton upside down to allow the heater to stand on its feet and remove the carton. Check that it is the correct model
and that it is in good conditions.
Check that all parts have been delivered and are intact.
-
1 Ecombi Solar heater casing.
-
1 bag containing 2 screws and 2 rawl plugs.
-
2 supporting feet.
-
This guide.
The casing and storage bricks are supplied separately. Check the supplied bricks packages correspond to the ones indicated on the
heater carton.
The heater operation is not affected if bricks with minor damage are used.
3. - Take off the front panel by removing the two screws located at the bottom. Fix the lateral fittings to the metal structure by
using the appropriate screws.
4. - Place ECOMBI SOLAR in your selected installation area. Use the heater fixing holes as a template and mark the wall through
the fixing holes with a pencil. Drill the required holes into the wall. Place the rawl plugs and screws into the holes before the
appliance installation but do not fasten them tightly.
5. Attach ECOMBI SOLAR to the rawl plugs with the crews. IT MUST NOT BE HUNG ON THE SCREWS; these are used only
to prevent the device from overturning and not to support it. If there is any doubt concerning the wall strength, consult the
corresponding construction specialist. The appliances are heavy; it is the installer responsibility the correct installation and wall
support of these devices to prevent them from overturning.
6. – Wire correctly the heater connecting Line, Neutral and Earth in the corresponding screw of the connection block. Tighten
properly the connection block screws. Do not leave any remaining wire inside the heater.
WARNING Touching live connections can cause serious personal injury.
13
Publicidad
