Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing Atlantic Color Changing Lighting. Atlantic's Lighting features solid
brass bodies with an oil-rubbed bronze finish or high-impact plastic housings. These Lights
create a vibrant nighttime atmosphere with a near unlimited number of colors with the
InfiColor Smart Module. Multiple fixtures can be connected to a single Smart Module and
controlled via mobile application on your Apple or Android device.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product failure,
or other problems.
• Follow all electrical codes when installing Atlantic Lighting.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Quick-connect plugs are gasketed for outdoor use and must be fully tightened to prevent
water infiltration. Quick-connect plugs are not waterproof and should not be submersed.
• Always use dielectric grease on all connections and verify that the lens ring is tightly secured
before submersing the fixture.
• Never shorten or cut the cord on Atlantic Color Changing Lights. Removing the driver or
cutting/shortening the cord will damage the LED and void the warranty.
• Extension cords (model #CCEXT20) are available to add an additional 20' of cord to
any Light.
• The InfiColor Smart Module is weatherproof, but must be mounted vertically above the
ground on a wall or post within reach of a properly grounded GFCI outlet. Do not submerse
the Control Module or expose it to heavy rainfall. Failure to do so will void the warranty.
• The InfiColor Smart Module can be connected to an existing 12 volt AC lighting system by
cutting and splicing the flat low voltage wire that supplies power to the Module.
• Adapters are included to adapt newer 5-wire lighting components and InfiColor Smart
Module to older 6-wire fixtures and control modules. USE ONLY ONE ADAPTER PER ZONE/
SEGMENT. COMBINING ADAPTERS WILL DAMAGE SYSTEM. DO NOT USE MORE THAN
ONE ADAPTER PER ZONE OR SEGMENT.
COMPACT SPOTLIGHTS - CCCS2 / CCCS4
Installation
Compact Spotlights offer three different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
• Ground stake: for installation around the perimeter of the water feature or
in conventional landscape installations
• Nestled: without the stand or stake, amongst the stones and gravel
Proper light placement is important for every project. Whenever possible, lights should be
positioned facing away from the viewing area to minimize glare and hot spots. When
camouflaging the light cord with rocks and gravel, always leave enough slack in the cord so
that the fixture can be raised above water level for servicing.
2
Publicidad
