Publicidad
Idiomas disponibles
Idiomas disponibles
• Use dielectric grease on all connections and ensure that all cable connections are secure.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter any round cords. Cutting or damaging any round cord will void the warranty.
CONNECTING LIGHTING TO MODULES
All Atlantic Color Changing Lighting is fully forward and backward compatible. Adapters are
included to adapt newer 5-wire lighting components and InfiColor Smart Module to older
6-wire fixtures and control modules. The adapters included with the InfiColor Smart Module are
for use with older lighting. The adapters included with new lighting components are for use with
the older Control Module.
CAUTION: COMBINING ADAPTERS WILL DAMAGE SYSTEM. DO NOT USE MORE THAN ONE
ADAPTER PER ZONE OR SEGMENT.
Apply dielectric grease, included with the InfiColor Smart Module and all new lights, to the
pins of the plugs on the Module and light cords. Line up the keys; the plugs will only fit one
way. Connect the plugs to the adapter and tighten the threaded ring. Complete the tightening
process by wiggling the connection and retightening the threaded ring 2-3 times until
firmly seated.
HOW TO CALCULATE WATTAGES & MAKE CUSTOM SETUPS
The InfiColor Smart Module provides 40 watts to each of three zones. The zones may be linked
and synchronized as desired. Add up the wattage of each light, which can be found in the
Catalog, the packaging, the instructions or the website, to find the total wattage of the group.
The wattage shown is the highest wattage that the light will draw, rounded up to ensure Smart
Module capacity is never exceeded.
There is also a limit to the length of any lighting run. The number of extension cords you can use
consecutively depends on the total wattage of the zone.
If your total wattage is:
0-10 watts - 4 extension cords max
10-20 watts - 3 extension cords max
20-30 watts - 2 extension cords max
30-40 watts - 1 extension cord max
INFICOLOR MOBILE APP
To connect your mobile device to the Smart Module, be sure the Module is plugged in
and open the InfiColor App. The app should populate your Smart Module on the opening
screen. Simply select the Module name. Please note the Module can be connected to one
mobile device at a time.
To Configure Zone Names and Timers
Click dropdown menu. Edit the names of the control module outlets or zones on the "Zone
Settings" page. These zone names will be visible throughout the app. Each zone has an
individual timer function to turn the zone on and off at set times. Click the "Save" button to save
changes. A box will come up confirming the settings have been saved. Click the "Back" button
once configuration is complete.
Color Tab
Use the Color tab to choose colors for the different zones using either the color picker or the red,
green and blue sliders at the bottom. Choose the brightness of the color by adjusting the slider.
Select the color for each zone, or select multiple zones to change color at the same time.
7
Publicidad
