Welby 14942 Manual De Instrucciones página 9

USA
Safety instructions
• in close proximity to large equipment with an ON/OFF
switching relay.
− If the cuff does not stop pumping up by itself, immediately
remove it and switch off the device in order to avoid any
injuries.
− Do not use a luer lock for the hose connection because it
could be inadvertently connected to a system managing
intravascular fluids. There is a danger that air could be
pumped into a blood vessel with fatal consequences.
NOTICE!
Risk of damage to the device due to improper handling.
− Protect the device and its accessories against moisture,
water in droplet or spray form and perspiration. Avoid
dust, heat and direct sunlight in order to prevent
malfunction.
− Make sure you do not knock the device, do not drop it and
do not place objects on top of it.
− Clean the device with a soft, dry cloth. Never use thinners,
alcohol, benzene or wet wipes to clean the device.
− Clean the cuff with a soft, dry cloth. Do not allow the cuff to
become wet.
NOTICE!
Environmental conditions such as temperature, air pressure and
humidity can influence the measurement results. Always take
the measurements under the same, approved environmental
conditions (also see the Chapter "Technical data").
14
866-633-4660
USA
AFTER SALES SUPPORT
us.info@medion.com