Starmix haaga 375 Manual De Instrucciones Original página 26

Operation
7.3 Set hold-down device
(haaga 477 / 497 Profi )
With the hold-down device, the right plate broom
is adjusted to the edge regions to be swept, for
example on walls or curbs.
EN
NOTE
An unsuitable setting of the hold-down device An unsuitable setting of the hold-down device
at lower edges can lead to excessive wear. at lower edges can lead to excessive wear.
The hold-down device must not scratch on the The hold-down device must not scratch on the
ground. ground.
1
Fig. 10: Hold-down device setting
Sweeping out edges and corners
• Press down the handle of the hold-down
device.
Operation on surfaces
• Pull up the handle of the hold-down device.
7.4 Operation
• Operate the device via the sliding bracket with
both hands.
• Push the device forward at normal walking
speed.
• Remove the sweeping container as needed,
see section "Empty sweeping container" in
Section 7.5 of this operating manual.
26
haaga 375
haaga 477 / 497 Profi
7.5 E mpty sweeping container
Fig. 11: Empty the sweeping container
• Empty the sweeping container after each use.
• Empty the sweeping container at regular
intervals to achieve a proper sweeping result.
1. Bring the sliding bracket (1) into the horizontal
position.
2. Pull the sweeping container (3) upwards by
the container handle (2).
3. Empty the sweeping container (3) completely.
» Make sure that the enclosure sides are free
of dirt.
4. Insert the empty sweeping container (3) on the
device.
5. Press the container handle (2) back into the
starting position.
» The sweeping container (3) must audibly lock
into position.
6. Bring the sliding bracket (1) back into the
operating position.