Walgreens WGNBPA-220 Manual De Instrucciones página 15

1. If the cuff is not assembled, pass the end of the cuff furthest away
from the tubing through the metal D-ring in order to form a loop. The
smooth side without the felt material should be on the inside of the
cuff loop.
2. Plug the cuff tube into the left side of the unit.
Insert Plug Here
3. Open the arm cuff so that your arm may be placed through it.
4. Remove tight-fitting clothing from your upper left arm so that the cuff
can be wrapped around your exposed arm.
NOTE:
It is recommended to wrap the cuff on a bare arm or over thin clothing
to ensure accuracy. Thick clothing or a rolled up sleeve will cause
inaccurate blood pressure measurements.
End of Cuff
D-ring
15