Dometic 9600000083 Instrucciones De Montaje Y De Uso página 12

Safety and installation instructions
Observe the following instructions when working with electrical parts:
• When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 2) or a voltmeter (fig. 1 9, page 2).
Test lamps with a bulb (fig. 1 12, page 2) consume voltages which are too high
and can damage the vehicle's electronic system.
• When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 3).
• Insulate all connections.
• Secure the cables against mechanical wear by using cable binders or insulating
tape, for example on existing cables.
The camera is watertight. However, the seals on the camera cannot withstand a
high-pressure cleaner (fig. 4, page 3). Therefore, you should observe the following
instructions when handling the camera:
• Do not open the camera, as this impairs the leak tightness and the function of the
camera (fig. 5, page 3).
• Do not pull at the cables, as this impairs the tightness and the function of the
camera (fig. 6, page 3).
• The camera is not suitable for use under water (fig. 7, page 3)!
12
PerfectView CAM604
EN