Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the camera
Creating a through-hole for the camera connection cable (fig. h, page 7)
I
NOTE
If possible, use available openings, such as ventilation grilles, to feed the
connection cables through. If there are no existing ducts, you must drill
a hole of Ø 16 mm.
A
NOTICE! Beware of damage
Check beforehand that there is sufficient space on the other side for the
drill head to come out.
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place a cable sleeve in all sharp edged ducts.
Fastening the camera
➤ Push the camera into the bracket (fig. i, page 7).
A
NOTICE!
Only use the screws supplied to mount the camera in the camera holder.
Longer screws will damage the camera.
➤ Secure the camera loosely with the four M4 x 6 screws in the two other fixing
holes (fig. i, page 7).
The camera is now centred.
➤ Align the camera so that the lens is at an angle of approx. 25° ± 5° to the vertical
axis of the vehicle (fig. k, page 8).
I
NOTE
Do not tighten the four M4 x 6 screws until you have aligned the camera
(see chapter "Checking the function and setting the camera" on
page 22).
To do this you must first install and connect a monitor.
20
PerfectView CAM604
EN
Publicidad
