Dometic 9600000083 Instrucciones De Montaje Y De Uso página 17

PerfectView CAM604
8 Fitting the camera
8.1 Tools required
For installation and assembly, you will need the following tools:
• Drill bit set (fig. 1 1, page 2)
• Electric drill (fig. 1 2, page 2)
• Screwdriver (fig. 1 3, page 2)
• Set of ring or open-ended spanners (fig. 1 4, page 2)
• Measuring ruler (fig. 1 5, page 2)
• Hammer (fig. 1 6, page 2)
• Centre punch (fig. 1 7, page 2)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)
• Crimping tool (fig. 1 10, page 2)
• Insulating tape (fig. 1 11, page 2)
• Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
8.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that it
cannot under any circumstances fall off and injure bystanders (e.g. by
being knocked off by branches brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length specified
in the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
This authority must note any such changes your vehicle documents.
EN
Fitting the camera
17