Accessmatic Bulldozar 824 Manual De Usuario página 33

824
BD824
Opening your life
Code:
Note:
1. If there is no operation under the limit switch position setting status, system will automatically exit after 20 sec.
2. If need to exit in the process of travel limit position setting, please press "PROG" once to directly exit.
5.4 Remote Control Learning
FIG.14
A. Operation Instruction
1. Press "+" button to enter into remote control learning status. Indicator lights L1 and L5 will icker alternately. (If an alarm lamp is
connected, it'll ash at the same time).
2. Press the button which is to be learned on the remote control. Indicator lights L1-L5 will be on for 1 sec. (If an alarm lamp is connected,
it'll be on for one sec.) Learning is nished.
3. The control board will exit learning mode after remote control learning successfully, the learning of the remain remote controls can be
done by repeating above steps; Press "PROG" button to exit the learning mode.
5.5 Remote Control Delete
FIG.15
This operation will delete all the remote controls saved on the control board.
A. Operation Instruction:
Press and hold "-" button for 3 sec,delete will be success and exit automatically . Indicator lights will be o in sequence from L5 to L1,
then indicator lights L1-L5 will be on for one sec.
www.accessmatic.com
Opening your life
12