Samsung WA40A3A Serie Manual Del Usuario página 23

WA3000A_DC68-03850F-00_EN.indd 23 WA3000A_DC68-03850F-00_EN.indd 23
4. Connect the ends of the water supply
hoses to the water supply intake
connections at the back of the washer.
CAUTION
The water supply hose connected to the hot
faucet must be connected to the hot water
supply intake and the water hose connected
to the cold faucet must be connected to the
cold water supply intake.
5. Tighten the fittings by hand until they
are snug, and then tighten them an
additional two-thirds of a turn with a
plier.
NOTE
To ensure correct water usage, connect both
the hot and cold water faucets. If either or
both are not connected, the Cool (no fill) LED
will flash.
NOTE
If you do not want to use the hot water
supply hose, insert the water intake cap
into the hot water supply intake hole. In this
case, you must select the Cold for the water
temperature. If you select the Cold, all the
lamps for the water temperature options are
turned off.
CAUTION
Confirm that the water supply hoses are not
twisted or bent. If the hoses are twisted or
bent, the hoses can leak and cause electric
shock due to the water leakage.
6. Turn on the hot and cold water supplies
and check all the water supply intake
connections and the faucets for water
leaks.
English 23
2020-12-07 2020-12-07 4:20:56 4:20:56