Temperature Measurement - Beta 1760 B Manual De Usuario E Información De Seguridad

TEMPERATURE MEASUREMENTS
WARNING: To avoid electric shock, disconnect both test probes from any source of voltage before
making a temperature measurement.
1 If you wish to measure temperature in °F, set the function switch to the °F range. If you wish
to measure temperature in °C, set the function switch to the °C range.
2 Insert the Temperature Probe into the negative (-) jack (COM) and the positive (+) jack (Tem-
perature), making sure to observe the correct polarity.
3 Touch the Temperature Probe head to the part whose temperature you wish to measure. Keep
the probe touching the part under test until the reading stabilizes (about 30 seconds).
4 Read the temperature in the display. The digital reading will indicate the proper decimal point
and value.
WARNING: To avoid electric shock, be sure the thermocouple has been removed before changing
to another measurement function.
Beta 1760 B.indd 41
1
21-05-2010 15:11:20