Makita DTD172RTJ Manual De Instrucciones página 13

Indication patterns
Application mode
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
Wood mode
Bolt mode
T mode (1)
T mode (2)
: The lamp is on.
: The lamp is blinking.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
► Fig.12
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
For tool with shallow driver bit hole
A=12mm
B=9mm
While registering the application mode
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
When the registered application mode
For tool with deep driver bit hole
A=17mm
B=14mm
A=12mm
B=9mm
Procedure 1
For tool without one-touch type sleeve
► Fig.13: 1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
13 ENGLISH
turns on
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.