Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
REMOVING PACKAGING AND SET UP
•
Remove packing box, foam, and bottom cardboard piece�
•
Open the washer door and remove all the accessories in the drum�
•
DO NOT use the washer on the foam packaging base�
•
Carefully lay the machine down�
•
Slide the noise proof plate into place over the opening in the bottom and attach with the mounting screw�
•
The washer should be installed on a stable surface close enough to the water supply, drain, and electrical
outlet to ensure that the hoses and power cord reach�
WARNING: Improper connection of the power cord can result in a risk of electric shock� Check with a qualified
electrician or serviceman if you are in doubt as to whether the appliance is properly grounded� DO NOT modify
the provided plug with the appliance – even if it will not fit into the outlet� Have a qualified technician install the
proper wall outlet for you�
INSTALLING THE WASHER
LOCATION
Move the empty washer by carefully tipping it back
about 60°~70° degrees until the casters on the rear
of the unit are able to roll on the floor� Do not try
to move the washer when it has clothes or water in
it, and have someone assist you if needed� Do not
install on carpet� Install washer on a level and solid
floor that can support its weight� Store and install the
washer where it will not be exposed to temperatures
below freezing or exposed to outdoor weather
conditions� Position the appliance so that the power
plug, water inlets, and drain are easily accessible�
INSTALL THE BOTTOM COVER
Slide the bottom cover into the slots on bottom
surface of the unit as in the following Figure 5, and fix
it with the screw attached with the unit�
LEVEL THE WASHER
The washer must be leveled prior to using� You can
check if the washer is level by checking the position
of the tub or using a bubble level�
1�
Slide the washer into position�
2�
Open the lid of the washer, and pour the water
into the tub to just below the pulsator level�
Front of
the Washer
Bottom Cover
8
Figure 4
Back of
the Washer
60-70°
Figure 5
Figure 6
Pulsator
Publicidad
