Installation Instructions - Magic Chef MCSCWD27W5 Manual Del Usuario

INSTALLATION INSTRUCTIONS

1� The washing machine must be properly grounded� In the event of a short circuit, grounding can reduce the
danger of electrical shock�
2� Washing machine should be operated in a circuit separate from other electrical appliances�
INCLUDED PARTS
Before starting installation, make sure all included parts are
in the package inside the drum�
INSTALLATION REQUIREMENTS
ELECTRICAL REQUIREMENTS
1� A 120v, 60Hz, AC 15-or 20amp, fused electrical supply
is required� A time-delay fuse or circuit serving only this appliance should be used�
2� This washer is equipped with a power supply cord having a 3 prong grounding plug�
3� To minimize possible shock hazard, the cord must be plugged into a 3 prong outlet, properly grounded in
accordance with local codes and ordinances� If a proper outlet is not available, it is the responsibility of the
customer to have the properly grounded outlet installed by a qualified electrician�
4� If codes permit and a separate ground wire to be used, it is recommended that a qualified electrician
determine the proper ground path�
5� DO NOT ground to a gas pipe�
6� Check with a qualified electrician if you are not sure the washer is properly grounded�
7� DO NOT have a fuse in the neutral or ground circuit�
8� Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing� Service Personnel – Do not contact the following parts while the appliance is energized: Drain
Pump, Door Lock, Drying Heater (Combo), Fan Motor (Combo)�
LOCATION REQUIREMENTS
Selecting the proper location for your washer improves performance and minimizes noise and possible washer
"walk�" The washer can be installed under a custom counter or in a basement, laundry room, closet, or recessed area�
You will need:
• A water heater set for 120° F (49° C)�
• A grounded electrical outlet located within 6 ft�( 1�8 m) of where the power cord is attached to the back of
the washer�
• Hot and cold water faucets located within 4 ft� (1�2 m) of the hot and cold water fill valves ,and water
pressure of 20 - 100 psi (137�9 - 689�6 kPa)�
• A level floor with a maximum slope of 1" (25 mm) under entire washer� Installing the washer on soft floor
surfaces, such as carpets or surfaces with foam backing�is not recommended�
• A sturdy and solid floor to support the washer with a total weight (water and load) of 200lbs�
• Do not operate your washer in temperatures below 32° F (0° C)� Some water can remain in the washer and can
cause damage in low temperatures�
Water Hoses (2)
7
Figure 2
Transport
Cable Tie Hole Plugs (4)