Publicidad
Safety Notes
• This model is only to be used with the operating system it
is designed for.
• Analog max. 15 Volts DC, digital max. 22 volts AC.
• This model must not be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the model is to
be run in conventional operation. The E611 655 interfe-
rence suppression set is to be used for this purpose. The
interference suppression set is not suitable for digital
operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
Important Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• Disposing: www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies the
warranty conditions.
Functions
• This model is designed for operation with H0 2-rail
DC systems (track according to NEM standards) with
conventional DC power packs.
• This model comes equipped with a Trix
connector for digital operation and can have
the Märklin locomotive decoder 60972 installed
in it.
• Trix motor vehicles must not be operated on digital
systems without an built-in engine decoder (Motor can be
damaged!).
• Headlights change over with the direction of travel.
• A 72270 (Märklin) smoke generator can be retrofitted to
the locomotive - also for analog operation.
• Minimum radius for operation is 360 mm / 14-3/16".
Operating Instructions
Information about retrofitting a digital decoder:
This locomotive has an electronic circuit (item no. E343384)
plugged into the digital connector instead of a connector
plug on the basic circuit board. This electronic circuit is
only required in analog operation. It must be removed when
retrofitting the locomotive with a digital decoder. See also
Page 21.
21
5
Publicidad
