Publicidad
Idiomas disponibles
Idiomas disponibles
Retainer Pin
Retulator Cap
4�
Remove the retainer pin that is currently positioned for use with Natural Gas� (Refer to Figure 15�)
5�
Turn the retainer pin upside down and re-install into regulator cap� (Refer to Figure 15�)
6�
Screw the regulator cap back into the regulator and reattach the regulator to the nipple and flare union�
(Refer to Figure 15�)
Converting Surface Hob burners (Natural Gas to LP Gas)
1�
Remove the burner grates, burner caps and burner heads�
2�
Using a 7 mm nut driver, remove the burner orifices�
Triple Ring burner - 5 Nozzles
3�
Install the proper orifices in replace of the ones that were removed�
4�
Re-install the burner bases, heads and top grates� Make sure the burner caps are properly seated on the
burner heads�
NOTE: The triple burner has only two injectors, one injector mounted in the center and one mounted below
the cover plate� To access the second injector, remove the two screws and the cover plate�
ImPORTANT: Once the conversion has been completed and has passed testing, fill out the conversion sticker
and include your name, organization and the date conversion is made� Apply the sticker near the cooktop gas inlet
opening to alert others in the future that this appliance has been converted� If converting back to Natural Gas,
remove the sticker so others know that the appliance is set to use its original gas�
Regulator
Nozzles
Auxiliary burner - 1 Nozzle
Semi-Rapid burner - 1 Nozzle
Rapid burner - 1 Nozzle
13
figure 15
figure 16
Publicidad
