Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTION
WARNING: Electrical Shock Hazard
• ALWAYS disconnect the electrical plug from the wall receptacle before servicing this unit�
• Plug into a grounded 3 prong outlet�
• DO NOT remove the ground prong from the power cord plug�
• DO NOT use an adapter�
• DO NOT use an extension cord�
• Failure to do so can result in death, fire or electrical shock�
NOTE: before making the connection, make sure of the following�
• The safety circuit breaker and the electrical system are able to withstand the load of the appliance�
• The power supply system has a ground connection in good working order in accordance with the regulation�
• The electrical socket should be easily accessible with the appliance installed� In all cases, the power supply lead
must be positioned so that it does not reach a temperature of 122°F above the room temperature at any point�
WARNING:
Severe shock or damage to the cooktop may occur if the cooktop is not installed by a qualified
service technician�
WARNING:
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniter of the cooktop, turn off all gas control knobs and wait 5 minutes for gas to dissipate before
lighting the burner manually�
WARNING:
To light the burner manually, carefully hold a lighted match to the burner ports and push and turn
the gas control knob to HI until it lights and then turn the knob to the desired setting�
Clamps
Assembling the burners
The electrode of the electronic ignition system is positioned above the surface of the burner base� DO NOT remove a
burner cap or touch the electrode of a burner while another is turned on� Damage or electrical shock may occur�
1�
Place burner heads over the burner base� Make sure the hole in the burner head is properly aligned with the
electrode in the burner base� (Refer to Figure 18�)
Copper or Stainless Steel Pipe
Rear View
Properly Connected
Clamps
Not Properly Connected
14
Rear View
figure 17
Publicidad
