Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Display unit
Power cord
Black, Orange/white, Red, Yellow
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the reverse gear
is engaged. Unless connected, the sensor may not
detect your vehicle travelling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note: When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect it.
When you use a rear view camera, please make
sure to connect it. Otherwise you cannot switch to
rear view camera picture.
Do not use other than the supplied extension lead.
☞
See Page 15.
Extension lead
(for reverse signal)
Note:
Cords for this product and those for other products may
be different colours even if they have the same func-
tion. When connecting this product to another product,
refer to the supplied Installation manuals of both prod-
ucts and connect cords that have the same function.
Yellow/black (GUIDE ON)
When combining this navigation unit with the other
Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, when the guidance audio is output
and when you operate the system by voice, the vehi-
cle stereo is automatically muted to reduce the vehi-
cle stereo volume.
☞
See Page 9.
Fuse resistor
Check the position of your vehicle's
reversing lamp (the one that lights up
when the gearstick is in reverse [R]) and
find the reversing lamp lead in the boot.
Connection method
Clamp the reversing lamp
lead.
Clamp firmly with
needle-nosed pliers.
Reversing lamp lead
12
Publicidad
