Descargar Imprimir esta página

LG LSSE3026 Serie Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
• Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack
in the line so that the range can be moved if
servicing is ever necessary.
• The power supply cord and plug should
not be modified. If it will not fit the outlet,
have a proper outlet Installed by a qualified
electrician.
• Using an extension cord to connect the
power is prohibited. Connect the power
cord and plug directly.
• Electrical ground is required on this
appliance.
• Make sure that the power cord is not
pinched by the range or heavy objects.
Failure to do so can result in serious burns or
electrical shock.
Specified power-supply-cord kit rating
Specified
Range rating, watts
rating of
supply-
120/240
120/208
cord kit,
volts
volts
amperes
3-wire
3-wire
8,750 -
7,801 -
40 or 50A
16,500
12,500
16,501 -
12,501 -
22,500
18,500
3, 4 - Wire electrical wall Receptacle
4 Wire receptacle (14-50R)
3 Wire receptacle (10-50R)
Connecting the Power Cord
The rear access cover must be removed. Loosen the
two screws with a screwdriver. The terminal block will
then be accessible.
Access cover
Diameter (inches)
of Range
connection
power
Opening
Power
Conduit
cord
1
/
1
/
3
"
1
8
8
50
1
/
1
/
3
"
3
4
8
Use the cord/conduit connection plate to install the
power cord or conduit. Leave the connection plate
as installed for power cord installations. Remove the
connection plate for conduit installations and use the
smaller 1
/
in. (2.8 cm) conduit hole instead of the
1
8
1
/
in. (3.5 cm) power cord hole.
3
8
1
/
" (2.8 cm) Conduit
1
8
1
/
" (3.5 cm) Cord
3
8
Remove the conduit connection plate
For power cord installations, hook the strain relief
over the 1
/
in. (3.5 cm) power cord hole located
3
8
below the rear of the oven. Insert the power cord
through the strain relief and tighten it.
"
Assembling power cord strain relief at the 1
"
For conduit installations, insert the conduit strain
relief in the 1
/
in. (2.8 cm) conduit hole. Then install
1
8
the conduit through the body of the strain relief and
fasten the strain relief with its ring.
Ring
Body
Assembling conduit cord strain relief at the 1
INSTALLATION
15
Conduit
connection
plate
Power cord
3
/
" opening
8
Cord/
Conduit
connection
plate
Conduit
1
/
" opening
8

Publicidad

loading

Este manual también es adecuado para:

Lsse3029 serie