Metabo SSD 18 LT 200 BL Manual Original página 12

en ENGLISH
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
11. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U = Voltage of battery pack
n = No-load speed
0
S = impact frequency
H = machine tool holder
m = weight (with the smallest battery pack)
M = min. tightening torque
1
M = medium tightening torque
2
M = max. tightening torque
3
Measured values determined in conformity with EN
62841.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission value (screwdriving with
h
impact)
K = uncertainty (vibration)
h
Typical A-weighted sound levels:
L = sound-pressure level
pA
L = acoustic power level
WA
K , K = Uncertainty (noise level)
pA WA
Wear ear protectors!
12