Publicidad
Idiomas disponibles
Idiomas disponibles
Untitled-8 23
1. Attach the water hoses to the hot and
cold water taps, and then hand tighten
the water hose fittings until they are
tight. Then, use pliers to tighten the
fittings by an additional two-thirds of a
turn. To avoid damaging the fittings, do
not overtighten them.
2. Pull the water hoses to check if they
are firmly connected.
3. Put the other ends of the hoses into
a bucket, and then open the water
taps for 10 - 15 seconds to remove
impurities. When done, close the taps.
4. Attach the water hoses to the hot and
cold water inlets on the back of the
washer, and then hand tighten the
water hose fittings until they are tight.
Then, use pliers to tighten the fittings
by an additional two-thirds of a turn.
NOTE
If you do not want to use the hot water
supply hose, attach the water intake cap to
the hot water supply intake. When you do
a wash, press Temp. to select Cold.
English 23
2019-03-15 PM 3:48:41
Publicidad
