Publicidad
Idiomas disponibles
Idiomas disponibles
Operations
05 Spin
06 Soil
07 Pre Soak
08 Steam
09 Delay End
10 Alarm Off
32
English
Untitled-8 32
Press to change the spinning speed for the current cycle.
• High (Level 5): Extends the spinning process to effectively
remove moisture from the load. This level uses a stronger
spinning process to remove moisture, so it is not suitable for
wrinkle-free or non-iron fabrics, or overloads.
• (Level 4): Underwear, t-shirts, jeans, and sturdy cottons.
• (Level 3): Jeans, wrinkle-free or wash-and-wear items, and
synthetics.
• (Level 2): Delicate items that require a lower spinning speed.
• No Spin (Level 1): The drum does not spin after the final drain
process.
Rinse hold (All indicators are off): The final rinse process is
suspended so that the laundry remains in the water. To unload the
laundry, run a drain or spin process.
NOTE
Spin Only: To perform the spin process only, press and hold Spin
for 3 seconds. With the cycle time on the display, press Spin
repeatedly until a desired spinning speed is selected. Then, press
and hold Start/Pause (Hold to Start) to start.
Press to change the soil level for the current cycle.
• Heavy (Level 5): For extremely soiled loads.
• (Level 4): For heavily soiled loads.
• (Level 3): For moderately soiled loads. This setting is best for
most loads.
• (Level 2): For lightly soiled loads.
• Light (Level 1): For barely soiled loads.
Press to add 30 minutes of soaking time at the start of the wash
cycle for better stain removal.
Press to use the Steam function. The Steam function is available
with NORMAL, HEAVY DUTY, WHITES, BEDDING, and SANITIZE.
For heavily soiled, colorfast items, this function improves stain
treatment and uses less water.
Set the washer to finish your wash automatically at later time.
Choose a delay of between 1 to 24 hours (in 1 hour increments).
(For more information about Delay End, see page 38.)
Press to turn the alarm sound on or off. When the alarm is off, the
cycle completion melody and the power-off beep will not sound.
However, button and alert sounds will remain on.
2019-03-15 PM 3:48:43
Publicidad
