Descargar Imprimir esta página

Black and Decker BDH1850SM Manual De Instrucciones página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

hand-heLd steaM cLeaner attachMents
notIce:
First remove the hand-held steam cleaner
from the steam body.
attachInG the hose
VarIaBLe noZZLe - fig. J
• Press in the clips (17) on either side of the hose (16)
or variable nozzle.
• Align the two keys on the inside flange of the hose
or variable nozzle with the two slots adjacent to the
steam nozzle on the hand-held steam cleaner or hose.
• Firmly press the hose or variable nozzle onto the
steam nozzle (18) of the hand-held steam cleaner or
hose such that it is fully seated, and release the clips.
WarnInG:
nozzle of the hose and handheld steam cleaner before
each use (figure k). If the seal is missing or
damaged contact your nearest authorized repair
agent. Do not use the appliance.
cautIon:
using the hand-held steam cleaner.
attachInG other accessorIes to the hose
• For accessories other than the variable nozzle, align the lugs (19) on the hose with the recesses
on the accessory.
• Press the accessory onto the hose and twist clockwise
until the accessory is fully seated and clicks into place.
reMoVInG other accessorIes
froM the hose
• For accessories other than the variable nozzle, twist
accessory counterclockwise then pull away from the hose.
reMoVInG the hose
• Press in the clips on either side of the hose and pull
away from the steam nozzle.
fILLInG the Water tank - fig. M
This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.
notIce:
Fill the water tank with regular tap water.
notIce:
In areas of very hard water, the use of
de-ionized water is recommended.
WarnInG:
jug (22) to fill tank, and do not fill jug above indicated max line.
• Ensure that the appliance is switched off and the
power cord is disconnected from the power supply.
• Place the steam mop on the resting mat (7) with the
handle tube (4) in the upright position.
• Open the filler cap (21) by pulling down.
• Fill the supplied jug (22) with water to the max line, and then use jug to fill water tank (3).
• Close the filler cap.
notIce:
Always empty the water tank after use.
cautIon:
not use the unIt uPsIde doWn.
sWItchInG on/off - fig. n
notIce:
When the steam mop is first turned on the
water reservoir will glow red. Once the steam mop is
ready to use the water reservoir will glow blue. It takes
approximately 15 seconds for the steam mop to heat up.
or
Inspect the seal on the steam
Ensure that the hose and/or variable nozzle is securely fastened before
Do not over fill the tank. Use supplied
oPeratIon
for fLoor use onLy; do
J
k
L
M
22
n
7
17
18
17
16
Seal
- fig. L
19
21
3

Publicidad

loading