Installation - Qlima ASE 1020 Manual De Funcionamiento

• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
• Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance
or perform user maintenance.
Disconnect from mains during installation, maintenance and cleaning. and/or filter replacement.
• Do not remove the plug from the socket by pulling the power cord.
• Only have the appliance repaired by the manufacturer or its authorized service agent
• Only use filters supplied by the manufacturer or its authorized service agent.
• Do not vacuum soot
• Do not use the appliance to vacuum: liquids, inflammable and/or explosive materials, corrosive
materials, hot and/or burning ash, matches, cigarettes.
• Do not open the motor compartment of the appliance. DANGER ! Live electrical parts!
• NEVER use the appliance without the filter!
• Empty and clean the appliance before vacuuming to avoid the collection of materials that could pose
a fire hazard inside the vacuum cleaner;
If you fail to consult and/or follow up the rules, instructions and explanation, the warranty will no
longer be valid, and the manufacturer will no longer deal with any damage to the appliance and/or
your environment under the warranty.

2. INSTALLATION

(refer to picture 1 and 2 page 3):
• Take out the appliance and accessories from the packing box, check the accessories and whether the
appliance enclosure is well-found or not. (picture 1 and 2)
• Loose the lock 3 and take the head part from the container 1.
• Attach the filter (ASE 1020: item B / ASZ 1010 item C / ASZ 1020 item C+D) set to the bottom of lid 3
• Put the lid 3 on the container 1 and use the lock 2 to fixate.
• Insert the nozzle 8 into the hose 7. Insert the other end of hose 7 into air inlet connection 6.
• (ASZ1020 only): click the wheels 11 firmly to the bottom of the container body 1. Make sure that
wheels 11 are evenly spread (see picture 2 )
• The nozzle 8 end rectangular nozzle 10 (picture 1 & 2): are used to vacuum ash in the fireplace (picture
5)
• Type ASZ only: Insert the power cord plug in the wall socket.
• Type ASE only: connect the hose of your normal home dust vacuum cleaner to suction connector 5
(picture 1). Connect your vacuum cleaner to mains and switch it on.
NOTE:
* the normal directions for use of your home dust vacuum cleaner remain applicable, the supplier of
your ASZ/ASE ash vacuum cleaner is not responsible in any way for your home dust vacuum cleaner.
No claims can be made whatsoever.
* always make sure the ash vacuum cleaner filter is properly installed. As otherwise your home dust
vacuum cleaner might be damaged.
The Ash Vacuum cleaner is now ready to use.
BLOWING FUNCTION: ASZ 1010 AND ASZ 1020 ARE FEATURED WITH A BLOWING FUNCTION:
• Put hose end 7 into the blower outlet connection 13. The air will now blow through the nozzle.
man_ASE1020_ASZ1010_ASZ1020 ('16).indd 23
23
09-06-16 11:10