Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
• Set the depth stop (7) to the desired position. The maximum drilling depth is equal to the distance between the
tip of the drill bit and the front end of the depth stop.
• Tighten the side handle by turning the grip clockwise.
USE
WARNING:
Let the tool work at its own pace. Do not overload.
WARNING:
Before drilling into walls, floors or ceilings, check for the location of wiring and pipes.
SELECTING THE DIRECTION OF ROTATION (FIG. D)
For drilling and for tightening screws, use forward (clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
• To select forward rotation, push the forward/reverse slider (3) to the left.
• To select reverse rotation, push the forward/reverse slider to the right.
WARNING:
Never change the direction of rotation while the motor is running.
SELECTING THE DRILLING MODE (FIG. E)
• For drilling in masonry, set the drilling mode selector (4) to the position.
• For drilling in other materials and for screwdriving, set the drilling mode selector to the position.
SETTING THE DRILLING DEPTH (FIG. F)
• Slacken the side handle (7) by turning the grip counterclockwise.
• Set the depth stop (6) to the desired position. The maximum drilling depth is equal to the distance between the
tip of the drill bit and the front end of the depth stop.
• Tighten the side handle by turning the grip clockwise.
SWITCHING ON AND OFF
• To switch the tool on, press the variable speed switch (1). The tool speed depends on how far you press the
switch. As a general rule, use low speeds for large diameter drill bits and high speeds for smaller diameter drill
bits.
• For continuous operation, press the lock-on button (2) and release the variable speed switch. This option is
available only at full speed. This option does not work in reverse rotation.
• To switch the tool off, release the variable speed switch.
• To switch the tool off when in continuous operation, press the variable speed switch once more and release it.
ACCESSORIES
The performance of your tool depends on the accessory used. Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance of your tool. By using these accessories you will get
the very best from your tool.
MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular cleaning.
WARNING:
Before performing any maintenance, switch off and unplug the tool.
• Regularly clean the ventilation slots in your tool using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner.
PROTECTING THE ENVIRONMENT
Separate collection.
This product must not be disposed of with normal household waste.
6
Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do
not dispose of it with household waste. Make this product available for separate collection.
Separate collection of used products and packaging allows materials to be recycled and used again.
Re-use of recycled materials helps prevent environmental pollution and reduces the demand for
raw materials.
Local regulations may provide for separate collection of electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker
location nearest you.
SPECIFICATIONS
KR508
Voltage
AR, B2C, B2
220V
B3, BR
120V/127V
Power input
550W
No-load speed
0-2800 rpm
Max drilling capacity
Concrete
13mm
Steel
13mm
Wood
20mm
Weight
1,9kg
ENGLISH
7
Publicidad
