GE PHC08 Manual Del Propietário página 6

Controls
Using the Remote Control
Remote Control may differ in appearance from the image
show.
NOTE: Please remove the back of the controller and insert
two AAA batteries. Replace batteries after 6 months of use
or when remote control starts to lose power.
NOTE: DO NOT mix old and new batteries.
1. POWER
Press the power button to turn on the air conditioner.
When you first press the power button, the air conditioner
will operate in Energy Save mode, Quiet fan speed and
temperature of 72°F. You can select any other mode to
satisfy your needs .
2. SPEED
High - Press HIGH button to choose high fan speed.
Med - Press MED button to choose medium fan speed.
Quiet
Auto Cool
speed.
3. MODE
Fan- Press the FAN button to activate fan mode.
Cool - Press the COOL button to activate cool mode.
E-Save Press the ENERGY SAVE button to activate
mode.
Dehum -
mode.
6
QUIET
HIGH MED AUTO
TEMP UP
ENERGY
FAN COOL
SAVE
TEMP DOWN
TIMER TIMER TIMER
ON/OFF
UP DOWN
DEHUM F/C SLEEP
LOCK
LIGHT RESET
4. TIMER
To set the air conditioner to turn off after a set
amount of time between 1 hour and 24 hours (unit
must be ON):
1. Press TIMER ON/OFF button on the remote control to
select the time off function.
to change the delay time from 1 hour to 24 hours.
Timer OFF indicator light on the air conditioner panel
will illuminate.
3. The buzzer beeps twice after 5 seconds, then Timer
OFF countdown will initiate.
To clear TIMER Program:
NOTE: Air conditioner can be either on or off.
Press TIMER ON/OFF button until Timer indicator light
turns off.
5. TEMP UP/TEMP DOWN
temperature will go up 1° F until it reaches 86°F (30°C).
• Press the TEMP DOWN button to lower the
temperature. Each time you press the TEMP DOWN
button, the temperature will go down 1° F until it
reaches 61°F (16°C).
6. SLEEP
1. Press SLEEP button on the remote control to choose
Sleep mode. This display will show (08) and the
indicator light will turn on.
2. The temperature will increase by 2° F one hour after
the mode is chosen. The temperature then increases
another 2° F after one hour. The until will hold this
temperature for six hours then stop.
3. To turn off Sleep mode, press the SLEEP button until
the indicator light is off.
7. FAHRENHEIT/CELSIUS
• Press the F/C button to choose between Fahrenheit
and Celsius.
8. LOCK
• Press the LOCK button on the remote control to
disable button functionality. Press the LOCK button
again to activate the remote control functionality.
9. LIGHT
• When you press the LIGHT button, the display on the
unit will turn off, but the unit is still operating normally.
When you press the LIGHT button again or press
any button on the remote control, the display will be
illuminated again.
10. RESET
• Press the RESET button to reset the unit to factory
settings.
49-5000295 Rev. 3