Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
7. INSTALL THE CASE IN THE
WINDOW
A. Open the window and mark the centerline of the
window stool.
B. Carefully place the case on the window stool and
align the center mark on the bottom front with the
centerline of the stool.
C. Pull the window down behind the top mounting
rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is restricted
D. Select the position that will place the sill
supports near the outermost point on the sill.
Place the short side of the sill supports, on the
case bottom, toward the window. Attach the sill
supports to the case track hole in relation to the
selected position using 2 Type B screws in each
support.
CAUTION
Do not install this air conditioner in
a window if the bolts do not contact the window sill.
E. Adjust the bolt and the nut in each support so
that the case is installed with a slight tilt to the
be the correct case slant to the outside.
CAUTION
If the sill support bolts do not
contact the window sill or if you have a window
without a sill you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit GEAppliances.com.
49-5000550 Rev. 0
7. INSTALL THE CASE IN THE
WINDOW
F. Secure the case to the window stool by using 3
G. Pull the accordion panels to each window sash
Long side of
sill supports
(cont)
Type D screws.
Sill
support
track. Attach them on each side to the window
sash and the window stool using 4 Type C
screws.
11
Publicidad
