Publicidad
Idiomas disponibles
Idiomas disponibles
3
INSTALL HOOD ONTO WALL
• Pull house wiring through knockout at the back or
top of the hood.
• Lift the hood and place over the hooks on the
installation bar. Allow the hood to slide down into
position.
• Check to be sure the hood is level and centered.
• Tighten wall anchor screws (C) to finish hood body
installation to the wall.
• Remove cover from junction box inside the hood.
Centerline of
Installation Space
49-2000707 Rev. 5
Installation Instructions
24" minimum over electric
range or cooktop, or 30"
minimum over gas range
or cooktop, and 36"
recommended maximum.
4 (Alternate Mounting Method)
INSTALL HOOD TO SOFFIT OR
CABINET
SKIP THIS STEP IF USING WALL MOUNTING
METHOD
IMPORTANT: Soffit or cabinet framing must be
capable of supporting 100 lbs. for 30" and 36"
models and 150 lbs. for 48" models.
When necessary the hood may be installed so that
it is supported by the soffit or cabinet.
• The soffit should be constructed with 2"x4"'s.
• Use a level to draw the cooktop or range center
line.
• Continue the centerline forward on the bottom of
the soffit.
• Install horizontal wood supports between the 2"x4",
at distance A to the left and right, as per the table
below.
B
A
A
C
"A"
"B"
Center-
Opening for
line to
Ductwork for
Center
top venting
Stud
30"
8-3/4"
Models
8-3/8" W x
11-1/4" H
36"
13-3/4"
Models
48"
10-5/8" W x
17-3/4"
Models
11-1/4" H
"C"
Opening for
Ductwork for
back venting
10-1/2" W x
13-1/4" H
19
Publicidad
