Descargar Imprimir esta página

Black and Decker FLEX BDH1220FL Manual De Instrucciones página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

• Remove the pleated filter from the pre-filter by pulling firmly as shown in figure K.
• Tap the filters vigorously to remove loose dust.
• If necessary, wash the filter (13) in warm, soapy water as shown in figure L.
• Make sure that the filter is dry before refitting it to the appliance.
• Refit the pleated filter into the plastic pre-filter.
TO REPLACE THE DUST CONTAINER
• Slide the container back onto the base and rotate the handle toward the front of the
appliance until an audible click is heard. Ensure that the
container is fully fastened back onto the base.
• Close the container door and make sure it clicks into place.
CLEANING THE DUST CONTAINER (FIGURE M - N)
• Unwrap the hose (4) and handle (2) from the main part of
the appliance.
• Push and hold the release button on the opposite side of
the handle from the dust container door (5).
• Rotate the handle toward the back of the appliance as
shown in figure M.
• Pull the dust container to the side, away from the base of
the appliance.
• Remove the pre-filter (22) and filter (23) from the
appliance by twisting the filter to the right and pulling it
from the appliance.
• Once filters are removed, wipe the dust container (10) and
pre-filter (23) with a damp cloth, or rinse with warm soapy
water and allow to dry as shown in figure N.
TO REPLACE THE DUST CONTAINER
• Slide the container back onto the base and rotate the
handle toward the front of the appliance until an audible
click is heard. Ensure that the container is fully fastened
back onto the base.
TROUBLESHOOTING
If the product does not work, check the following:
• The charger was correctly plugged in for recharge.
• The charger cord is not damaged and is correctly attached
to the charging base.
• The charger is plugged into a working electrical outlet.
• The appliance was switched to the "off" position to charge. The battery will not be
charged with the switch in the "on" position.
• One of the filters may be clogged. Pull the door latch and open the dust container door.
Remove the pre-filter and the pleated filter. Brush any loose dust off the filters and wash them
in warm, soapy water. Make sure the filters are dry before placing back in the vacuum.
For assistance with your product, visit our website www.blackanddecker.com for the location of
the service center nearest you or call the BLACK+DECKER help line at 1-800-544-6986.
BATTERY REMOVAL AND DISPOSAL
This product uses Lithium Ion rechargeable and recyclable batteries. When the batteries
no longer hold a charge, they should be removed from the Vac and recycled. They
must not be incinerated or composted. The batteries can be taken for disposal to a
Black+Decker, Company-Owned or Authorized Service Center. Some local retailers
are also participating in a national recycling program (see "RBRC™ Seal"). Call your
local retailer for details. If you bring the batteries to a Black+Decker Company-Owned or
Authorized Service Center, the Center will arrange to recycle old batteries. Or, contact your
local municipality for proper disposal instructions in your city/
town.
To remove The baTTery pack for disposaL:
1.) Before attempting to disassemble the product, turn it on
and leave it on until the motor completely stops, ensuring a
complete discharge of the battery.
2.) Remove the dust container (10) as described in the
"CLEANING THE DUST CONTAINER" section.
3.) Invert the appliance to gain access to the screws that
attach the base.
7
M
N
10
O
25
22

Publicidad

loading