EINHELL TE-DH 12 Manual De Instrucciones página 23

Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2 – Item 4)
For safety reasons you must only use the hammer
drill with the additional handle.
The additional handle (4) enables you to achieve
better stability whilst using the hammer drill. For
safety reasons the machine must not be used
without the additional handle (4). The additional
handle (4) is secured to the impact drill by a
clamp. Turning the handle anti-clockwise (viewed
from the handle) will release the clamp. Turning
the handle clockwise tightens the clamp. Release
the clamp of the additional handle fi rst. Then you
can swivel the additional handle (4) into the most
comfortable working position for yourself. Now
turn the additional handle in the opposite direction
again until the additional handle is secure.
5.2 Tool insertion (Fig. 3)
•
Clean the tool before insertion and apply a
thin coating of drill bit grease to the shaft of
the tool.
•
Pull back and hold the locking sleeve (2).
•
Insert the dust-free tool into the tool mounting
as far as it will go whilst turning it. The tool will
Anl_SA_TE_DH_12_SPK8.indb 23 Anl_SA_TE_DH_12_SPK8.indb 23
GB
lock itself.
•
Check that it is properly secure by pulling the
tool.
5.3 Tool removal (Fig. 4)
Pull back and hold the locking sleeve (2) and re-
move the tool.
5.4 Chisel lock (Fig.5 Item 3)
When the chisel lock (3) is pressed, you can turn
the inserted chisel into the required position.
•
Press the chisel lock (3) towards the inserted
chisel.
•
While holding the chisel lock (3), turn the chi-
sel into the required position.
•
Let go of the chisel lock again.
Note:
Turn the chisel to check whether it is securely
seated.
6. Operation
Important.
To avoid danger, the machine must only be
held using the two handles (1/3). Otherwise
you may suff er an electric shock if you chisel into
cables.
6.1 Switching On and Off (Fig. 6)
Switching on:
Press the On/Off switch (6)
Continuous operation:
Secure the On/Off switch (6) with the On/Off
switch lock (5).
Switching off :
Press the On/Off switch (6) briefl y or let go.
6.2 Practical tips
6.2.1 Sharpening chisel tools
You will only achieve good results if you use sharp
chisels. You should therefore sharpen the chisels
promptly to ensure that they produce good results
and provide a long service life.
- 23 -
16.05.2018 08:03:20 16.05.2018 08:03:20